Orac Xterio Dentil TF05

TF05
TF05
TF05
TF05

TF05 dentils are usually installed at eaves level on executive homes built to mimic detailing from the Victorian era. The plain inlay detail on the TF05 also lends itself to installation beneath shallow projection door canopies.

Each TF05 dentil is manufactured in a tough polyurethane material and supplied in a pre-finished white. These are usually installed with the 135mm section against the wall and the 255mm length projecting along the underside of the soffit. These dentils are typically spaced at 600mm centres. To achieve an architectural balance we recommend using the TF04 dentil on soffit sizes of approximately 300mm.

Each dentil should be fixed from above by two suitable screws (not supplied) prior to the roof being felt and battened. Retro-fitting on property refurbishments can be achieved, call us to discuss appropriate procedures.

Click for full fitting instructions.

Product Availability: Allow 2-3 days – can be bought individually if required, or in cartons of 42 units. We offer free samples to any NHBC House Builder.

Price: £39.00 including VAT
Material: Lightweight Polyurethane Profile with white RAL 9003 exterior grade automotive paint finish Projection: 255mm
Warranty: 10 years (When installed in accordance with Manufacturer's guidelines) Height: 135mm
Standard Finish: White RAL 9003 exterior grade automotive paint finish Width: 100mm
PDF downloads Downloads:  TF05 Technical Drawing  -  Dentil Installation Diagram (TF01)  -  Dentil Installation Diagram (TF02)

Orac Dentil Range

Orac TF01 Xterio Dentil
350 x 123 x 77mm
Orac TF02 Xterio Dentil
105 x 120 x 77mm
Orac TF03 Xterio Dentil
200 x 100 x 77mm
Orac TF04 Xterio Dentil
200 x 250 x 77mm
Orac TF05 Xterio Dentil
255 x 135 x 100mm
Orac TF06 Xterio Dentil
175 x 155 x 75mm
Orac RF01 Xterio Rafter Boot
113 x 65 x 48 mm